Things You'll Need:
- Trim
- Glamorous Fabrics
- Irons
- Sewing Machine
- Straight Pins
- Straight Pins
- Scissors
- Scissors
-
Step 1
Choose a fabric - and don't be shy. Think glorious velvets, shiny taffetas, stiff tulles and glowing lamés and - above all - sequins. If you can find the fabric cheap enough, make two skirts and layer them (silver chiffon over red velvet?).
-
Step 2
Buy 5 yards of fabric (if you're making just one skirt). For simplicity, try to get fabric that is 45 inches wide. This will give you a tree skirt just under 90 inches in diameter after hemming - big enough for just about any tree. If you want a contrasting trim, buy 15 yards (it sounds like a lot, but trims vary significantly in price).
-
Step 3
Then...
-
Step 1
Fold the fabric in half lengthwise, and then in half again to make four layers. (You'll have a perfect square four layers thick - each side 45 inches.) Cut along the folds to create four equal squares. Leave them stacked.
-
Step 2
Hold a tape measure with your left hand at the bottom left corner of the stack, pull it out with your right hand to measure 45 inches to the bottom right corner, and make an arc by moving your right hand gradually to the top left corner of the fabric (stop and mark every few inches with a fabric pencil); this will define a quarter circle. If you're left-handed, reverse these directions.
-
Step 3
Cut along the curve you've just marked to create the outside edge of your tree skirt.
-
Step 4
Measure 3 1/2 inches in from the bottom left corner and repeat the arcing and marking step to create a much smaller quarter circle.
-
Step 5
Cut along the smaller arc to create the cutout for the tree trunk.
-
Step 1
Take two quarter-circle pieces and place them together with right sides in, matching the small and large arcs.
-
Step 2
Pin along one straight edge and sew, using a sewing machine.
-
Step 3
Open out - you'll have a half circle.
-
Step 4
Pin one straight edge of each remaining quarter circle to either side of the half circle, right sides together, and sew, using a sewing machine.
-
Step 5
Open out - you'll have a full circle with a circular opening in the middle and a slit all the way through it - like a cape.
-
Step 6
Narrow-hem the inner hole, the two long edges that form the opening of the skirt, and the outer edge. To do this, turn over 1/4 inch of fabric along the area you are hemming and press; turn over another 1/4 inch and press again; then machine stitch.
