How to Attach Insulation to a Steel Arch Building
Insulation is used to help insulate buildings and houses and comes in various thicknesses and sizes to fit the needs of any homeowner. While insulation is often stapled to wood studs, it is also sometimes attached to steel studs. Attaching insulation to steel studs is slightly different than attaching it to wood studs, and if you happen to be working in a steel arch building, there are also some specific instructions you must follow to ensure the insulation is secure in the arch. Does this Spark an idea?
Other People Are Reading
Things You'll Need
- Tape measure
- Acoustical sealant
- Caulk gun
- Utility knife
- Plastic sheathing
- Double-sided carpet tape
Instructions
-
-
1
Measure the length and width of the area where you will be installing the insulation, and multiply the two together to get the total square footage of the entire area. This will determine how much vapor barrier and insulation will be needed for installation.
-
2
Slide a tube of acoustical sealant into a caulk gun, and cut off the tip at a 45 degree angle with a utility knife. Line up the caulk gun at the first end of the steel arch and press the tip up firmly against the steel.
-
-
3
Press the trigger and release a thin 1/4-inch bead of sealant along the steel framing. Continue over a small area, placing one bead every 6 inches, and set the caulk gun down. Roll out the plastic sheathing. This will act as a vapor barrier. Press it up firmly against the sealant. The sealant will hold it in place. Run it down along the entire steel framed wall.
-
4
Add more sealant over the next area, and roll out the plastic sheathing. Continue in the same manner over all of the steel studs until they are covered in the vapor barrier. Overlap the rows by 4 inches, so they are properly sealed.
-
5
Roll out the insulation and place it between the studs. Add double-sided carpet tape to the studs and against the insulation. Place a piece of tape every 8 inches up each stud and into the arch of the building. Press the insulation up against the double-sided tape, and continue in the same manner around the entire building until the arch and walls are complete.
-
1
