The frame of your rocker recliner attaches to a hinged box. The hinges enable the recliner to rock back and forth. Some recliners have a lever that allow you to adjust how far the recliner will rock, but they do not offer an on/off switch that allows you to turn off the rocking mechanism completely similar to ones located on office chairs. If you want to stop your recliner from rocking, you must install a wedge between the frame for the chair and the frame of the hinges box.
Step 1
Measure the height between the bottom of the chair frame and the top of the hinged box with your tape measure. Measure the length of the frame box from left to right.
Video of the Day
Step 2
Cut a piece of hardwood to match the height and the length. Use wood at least 1 inch thick to allow for easier mounting. Use a table saw, band saw or scroll saw to cut the hardwood to size.
Step 3
Drill a pilot hole with a 1/8-inch drill bit through the top of the hardwood block approximately 1/2 inch from each end.
Step 4
Wedge the wooden block between the chair frame and the hinged box. Double-check that the recliner will not rock backward.
Step 5
Secure the hardwood block to the hinged box with 2-inch wood screws and a screwdriver.
Video of the Day