Seiko Black Monster Bracelet Installation
The Seiko Black Monster watch is an analog watch designed for use by divers. It has time and date features and a bezel for timing. It is also powered by kinetic motion, meaning that you do not have to change the battery. If for any reason you need to replace the polyurethane bracelet on the watch, then you will need to disengage the spring bars holding the strap to the watch casing. Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Insert the forked end of a spring bar tool in the small between the watch casing and the side of the watch strap. Engage the spring bar and push toward the middle of the strap. As the spring bar compresses, move the strap to one side so that the spring bar will not re-enter the holding slot.
-
2
Remove the strap from the watch. Pull out the spring bar. Repeat the process on the other end of the strap.
-
-
3
Feed the spring bars into the empty slots of the new strap. Orientate the new strap with the buckle end at the top of the watch casing and the loose end at the bottom.
-
4
Guide the end of a spring bar into the holding slot on the watch casing. Push down on the other end with the spring bar tool to compress the spring bar.
-
5
Release the spring bar when it is between the two holding slots. Guide the spring bar so that it lodges into the holding slot. Give the bracelet end a tug to check that it is secure.
Repeat the process on the other end of the strap.
-
1
