Scala Rider Instructions

Scala Rider coordinates rider chats, mobile phone calls and GPS instructions in your motorcycle helmet.

In a wireless world, Scala Rider seeks to securely integrate communications for motorcyclists: hands on the handlebars (motorcycle or otherwise), attention on the road, and the freedom to process verbal integration inside the helmet. In fact, riding enthusiasts can engage phone calls and accept verbalized Global Positioning Systems (GPS) instructions if lost. However, Scala Rider must be digitally integrated in the same way that consumers patch together their audio components. Once programmed, motorcyclists need only attach the hardware to the helmets. However, the coordinated communications come with careful and methodical instructions, especially for driver and passenger headsets.

Things You'll Need

• Two Scala Rider Headsets:
• Driver unit
• Passenger unit
• Mobile phone user manual
• GPS user manual

Instructions

Configuring Bluetooth

1. Charge the headset by connecting its charging jack to an electrical outlet. The red light will turn off when the charge is complete.

2. Turn on your mobile phone and activate its Bluetooth function.

3. Press and hold down the "CTRL" button on the Scala Rider's Unit until the red and blue lights begin alternating rapidly.

4. Find and select "Scala Rider TeamSet" from the "Bluetooth Devices" menu on your phone (consult your phone's user manual for assistance if needed).

5. Punch in your four-digit personal identification number (PIN) when prompted. This number will be your pass key in the future.

6. Confirm the pairing. Your phone will give you a message that the pairing succeeded, and the headset will slowly flash in blue.

Configuring GPS

1. Turn on your GPS device.

2. Press the "CTRL" button on the driver's unit headset until red and blue lights begin alternating rapidly.

3. Find and select "Bluetooth Headsets" on your GPS device (consult your GPS user manual for assistance if needed).

4. Enter a four-digit PIN if prompted by your GPS device.

5. "Pair" your mobile and GPS devices by following manufacturer's instructions for each device. This integrates all Scala functions: intercom between riders, phone calls and GPS instructions.

Standard Hardware Installation

1. Loosen the two screws on the back plate of the helmet clamp (use the enclosed Allen key).

2. Slide the back plate between the internal padding and external shell of your helmet.

3. Vertically adjust the clamp location so that the microphone is in front of your mouth (dead center for signal clarity when speaking).

4. Attach the speakers to the Velcro inside your helmet opposite your ears (short speaker cord for the left ear [A], the long speaker cord [B] for the right ear). If necessary, use the Velcro pad supplied in the Scala package.

5. Tap the "Volume" button up or down to increase or decrease headset volume.

Tips & Warnings

• Check the user manual for status lights chart.

• Check to make sure that both your personal mobile phone and GPS units can be connected with an external device before purchasing Scala Rider.

• The two rider headsets are "paired" upon manufacture, but may need to be "re-paired." If so, consult page five of the user's manual.

References

• Cardo Systems, Inc.: Scala Rider TeamSet User Guide.

Resources

• CBS Interactive CNET Review (Scala Rider).
• Motorcycle USA LLC: Motorcycle USA Review; Bryan Harley; Oct. 2008.
• Youtube, Inc: Scala Rider Multiset Review (Video).
• Hearst Communications, Inc.: Motorcycle Safety Gear Gift Guide; Ty van Hoodonk.
• Ultimate Motorcycling.com: Scala Rider MultiSet Pro Review; Ron Lieback; May 2011.
• Cardo Systems, Inc.: Scala Rider TeamSet User Guide.