eSpring Installation
The eSpring Water Purifier uses ultraviolet light technology and a carbon-block filter to provide clean, clear water from the faucet. It destroys bacteria, viruses, pesticides, lead, mercury and radon. Feel confident you are drinking clean water in your own home by installing the eSpring Water Purifier to your existing kitchen faucet. Does this Spark an idea?
Instructions
-
-
1
Remove the wire screen and washer from the end of your faucet by turning it clockwise with your hand until it is detached from the rest of the faucet.
-
2
Attach the water purifier's diverter to the end of the faucet by turning it counterclockwise and tightening it with your hand. If the diverter does not fit, connect one of the adapters to the faucet by turning it counterclockwise and then attach the diverter.
-
-
3
Remove the two textured nuts, located on the back of the diverter, by turning them counterclockwise with your hand.
-
4
Push the two nuts onto the two tubes and place the tubes onto the knobs the nuts were removed from in the last step.
-
5
Tighten the nuts on the knobs by turning them clockwise.
-
6
Remove the top cover from the water purifier by pulling it upward and insert the tubes into the brackets, located on the rear of the unit. The tubes are attached when you feel resistance and cannot push them any further.
-
7
Insert the cord connected to the power adapter into the hole located on the top rear of the purifier and replace the top cover by pushing it down until it clicks.
-
8
Plug the power adapter into the wall outlet and wait about 30 seconds for the purifier to beep, signaling it is ready for use.
-
1
Tips & Warnings
Run only cold water through the eSpring Water Purifier. The purifier is treating your water when the pin on the front of the diverter is pulled out. If it is pushed in, your water is flowing through untreated.
