Installing a Wireless Router in Linux

NDISWrapper

Prior to installing the wireless router, you must install a program called "NDISWrapper." You can do this by searching for the program name in the "Add/Remove" utility found under the "Applications" menu. NDISWrapper will allow you to install the Windows Device Drivers that will be necessary for your computer to interact with your wireless router.

Physical Installation

The physical installation of a wireless router into a Linux computer does not change from a Windows computer. Simply make sure your modem is active and providing a signal, and then using ethernet cables connect your modem to your router. Your router will then begin to broadcast the wireless Internet signal, which computers with wireless access can then pick up. If the need arises, you can also have the option of connecting computers to your router via ethernet cables.

Router Settings

The final step to installing a wireless router into Linux is to install your router software and check its settings. By placing the router installation disc into your computer's disc drive, the installation Wizard will auto load. This is a utility that guides you through the setup process. Because you have installed NDISWrapper, your Linux operating system will be able to understand and use the drivers that are about to be installed. You can change any specific settings about your router from the Wizard. When you are done, select "Continue," at which point the files will install and you are ready to use your new wireless router.