Troubleshooting a Roper Washing Machine

Save

Washer Doesn't Spin

  • If your Roper washer works fine except for not spinning, try setting the timer to manual. If it spins, it means the timer is bad and must be replaced. If it doesn't spin, the lid switch is bad. You can verify this by removing the lid switch and connecting the wires together. The washer should start to spin.

Washer Fills, Then Stops

  • When your Roper washer fills and stops, the problem is the lid switch--the washer doesn't know that the lid is closed. Verify by removing the lid switch and connecting the two wires with a wire nut. The washer should operate normally.

Water Keeps Running or Draining

  • If your Roper washer seems stuck on a cycle, check that the top of the drain hose is higher than the water level in the washer. If it's not, the washer won't operate properly. Do not seal the drain hose because it needs air for water to drain properly. If the water still keeps running, you have a broken water inlet valve assembly which will need replacing. Contact your service technician.

General Troubleshooting

  • If your washer leaks, check that fill hoses are tight and not kinked. Next, check that the washer is level and that the drain is not clogged. When you have problems starting the washer, check that the circuit breaker hasn't tripped and that the timer is properly set, then pull the knob to start. If nothing happens, make sure the water is turned on. If it is on, turn it off and remove the hoses to check the inlet valves for debris blocking the water flow. Remove any foreign matter and reconnect the hoses.

Related Searches

Promoted By Zergnet

Comments

Resources

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!