How to Troubleshoot a Motorcycle's Front Brake

by Chris Gilliland
itstillruns article image
manette des gaz 2 image by Jerome Dancette from Fotolia.com

Your motorcycle's front brake is relied on heavily for nearly every braking maneuver found on the road or trail, making it a vital part of the machine's performance. When problems arise within the front brake circuit, your safety, as well as the motorcycle's ability to brake, are put at risk. Taking detailed notes of the symptoms, such as a mushy brake lever, abnormal noises or vibration, will help you to pinpoint the exact problem. These notes will also help a motorcycle technician determine the right repairs, should you not be able to troubleshoot your motorcycle's front brake yourself.

Symptom: Soft Brake Lever

Step 1

Inspect the front brake hose and its fittings on the master cylinder, positioned on the right handlebar, and the front wheel's brake caliper. Look for obvious signs of damage, such as cracks or leaks that can allow air and dirt to enter the brake circuit. Replace the brake hose and fittings if they are damaged in any way.

Step 2

Inspect the front brake master cylinder for leaks. Look specifically at the mating area around the brake fluid reservoir and at the piston below the brake lever. Replace the brake piston or fluid reservoir if there is any sign of leakage at either part.

Step 3

Unscrew the front brake master cylinder's fluid reservoir, using a Phillips screwdriver. Lift the reservoir diaphragm out of the master cylinder and inspect the condition of the brake fluid. Drain and flush the brake circuit if the brake fluid is dark brown or is contaminated by debris.

Step 4

Unbolt the brake caliper from the front fork, using a socket wrench. Pull the caliper off of the front brake disc. Inspect the exterior of the caliper for signs of leakage at the brake hose. Inspect the inner mount of the caliper for signs of leakage around the brake pad pistons. Replace the brake caliper if it is damaged in any way.

Step 5

Flush the brake circuit. Fill the master cylinder's brake fluid reservoir with new brake fluid. Place a plastic tube over the bleed valve on the front brake caliper. Open the bleed valve, turning the valve counterclockwise a half of a turn with a wrench. Pull in the brake lever and hold it in place. Close the bleeder valve, turning the valve clockwise with a wrench. Release the brake lever slowly. Repeat until the fluid trapped in the plastic tube is clear and free of sediment or bubbles.

Symptom: Vibration or Noise

Step 1

Unbolt the brake caliper from the front fork, using a socket wrench. Pull the caliper off of the front brake disc.

Step 2

Inspect the caliper's brake pads, looking specifically for uneven material wear on both brake pads. Replace the brake pads and inspect the front brake disc if the pads are unevenly worn. Measure the remaining amount of pad material, using digital calipers, if the pads do not exhibit signs of uneven wear. Replace the brake pads if there is less than 1 mm of pad material remaining.

Step 3

Inspect the inner and outer face of the front brake disc for scarring or signs of obvious damage. Replace the front brake disc if the damage is deep enough to catch your fingernail on.

Step 4

Lift the front wheel off of the ground, using a motorcycle stand. Rotate the front wheel slowly and observe the front brake disc for signs or warping or distortion. Replace the front brake disc if it is warped or distorted in any way.

More Articles

article divider
×