How to Build a Midcentury-Inspired Plant Stand

Hunker may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Welcome to Plant Week: Our guide to all things indoor plants, including tips for beginners, advice on care, and tons of plant-spo.

If you're looking for a stylish yet minimalist plant stand, this do-it-yourself midcentury-inspired planter is a simple solution for your indoor plant needs, whether you're adding plants that naturally clean the air or houseplants that make every room smell good. This project is fairly easy, as far as furniture building is concerned, and doesn't require any previous woodworking knowledge.

Advertisement

Things You'll Need

Video of the Day

All measurements will depend on the size of pot you choose to use. The pot featured here is 10.6 inches high by 11 inches wide by 11 inches deep.

Video of the Day

Step 1

Cut the 1-inch dowels into 17-inch lengths. These will become the legs of the stand. Mark the bottom of each leg for reference in the following steps.

Advertisement

Step 2

Clamp the 1 1/2-inch-by-3/4-inch pine board in place and use a 1-inch Forstner to cut two 10 3/4-inch cross braces. This is much easier on a drill press, but it is not necessary.

Advertisement

Step 3

Find the center of each cross brace and use a hand saw and chisel to remove a 3/4-by-3/4-inch slot in each piece so they can interlock.

Advertisement

Advertisement

Step 4

With a 1/4-inch drill bit, drill a hole 7 3/4 inches up from the bottom of each leg, being careful not to drill all the way through.

Advertisement

Step 5

Using the same 1/4-inch drill bit, drill a hole in the end of each cross brace. Insert a 1/4-inch dowel pin, and test-fit the pieces together.

Advertisement

Use sandpaper to remove any rough edges.

Advertisement

Step 6

Apply wood glue in all joints and firmly clamp in place. We used scrap pieces to help the clamps get a grip on the legs. Wipe away any excess glue and let dry overnight.

Advertisement

Advertisement

Step 7

When the glue is completely dry, slip the two halves together and apply your choice of paint or stain. We used Minwax Early American 230.

Advertisement

Insert the pot into the stand and fill with your favorite plant.

Advertisement

Advertisement

Report an Issue

screenshot of the current page

Screenshot loading...