eHow Home Blog

How to Build a Mid-Century Inspired Plant Stand that Looks Like it Belongs in a Dwell Magazine


Building a Mid-Century Plant Stand

If you’re looking for a stylish yet minimalist plant stand, this do-it-yourself Mid-Century inspired planter is a simple solution for your indoor plant storage needs. This project is fairly easy, as far as furniture building is concerned, and doesn’t require any previous woodworking knowledge.

Things You Need

  • Large ceramic pot
  • 1-inch wood dowels
  • 1 1/2-inch-by-3/4-inch pine board
  • 1/4-inch dowel pins
  • Saw
  • Drill or drill press with 1-inch Forstner bit
  • Chisel
  • Sandpaper
  • Wood glue
  • Wood stain

Modern white planter

All measurements will depend on the size of pot you choose to use. I bought mine from Lowe’s — 10.6 inches high by 11 inches wide by 11 inches deep.

Cutting the dowels to size

Cut the 1-inch dowels into 17-inch lengths. These will become the legs of the stand. Mark the bottom of each leg for reference in the following steps.

Cutting the cross braces with a Forstner

Clamp the 1 1/2-inch-by-3/4-inch pine board in place and use a 1-inch Forstner to cut two 10 3/4-inch cross braces. This is much easier on a drill press, but it is not necessary.

Holding the cross brace to a dowel

Fitting the two cross braces together

Find the center of each cross brace and use a hand saw and chisel to remove a 3/4-by-3/4-inch slot in each piece so they can interlock.

Drilling a hole into the dowel

With a 1/4-inch drill bit, drill a hole 7 3/4 inches up from the bottom of each leg, being careful not to drill all the way through.

Drilling a hole into the cross brace

Inserting a dowel into the cross brace, then fitting the cross brace into the hole in the stand

Using the same 1/4-inch drill bit, drill a hole in the end of each cross brace. Insert a 1/4-inch dowel pin, and test-fit the pieces together.

Use sandpaper to smooth any rough edges

Use sandpaper to remove any rough edges.

Apply wood glue and clamp the pieces together while drying

Apply wood glue in all joints and firmly clamp in place. I used scrap pieces to help the clamps get a grip on the legs. Wipe away any excess glue and let dry overnight.

Applying stain to the plant stand

When the glue is throughly dry, slip the two halves together and apply your choice of paint or stain. I used Minwax Early American 230.

Placing the pot into the completed stand

Insert the pot into the stand and fill with your favorite plant.

Completed mid-century plant stand

Mid-century plant stand

Photo credits: Cameron Oden

More from Cameron Oden

How to Transfer Ink to Wood

How to Craft Your Own Wood Beer Caddy

How to Build a Wood Bike Basket

Promoted By Zergnet


Is DIY in your DNA? Become part of our maker community.
Submit Your Work!