Interior Home Repair

While constructing a new sink mount or just changing out an old sink for a new cast iron sink, holes must be drilled through the cast iron for mounting. Cast iron is one of the hardest forms of...

Mice can find a home in ovens that are never turned on. They are attracted to the warmth of the pilot lights, the food crumbs left in the stove, and the proximity to other food in the kitchen. ...

Corian is a common material used for countertops and stove tops. Because of its makeup, it has many other applications as well and further has the ability to be manipulated and sculpted. Created...

Bathroom vents help dissipate the heat and water condensation from showers that can cause mold and mildew. A bathroom can be easily vented to the soffit in your attic roof with a few basic...

Drywall, also known as wallboard, plasterboard or gypsum board is the material most builders use to finish interior walls. Drywall looks impervious but it is only 1/4" to 5/8" thick, making it...

Paneling is actual wood that covers the wall from top to bottom, so you shouldn't be able to see any of the product behind the paneling. However, if you plan to drill holes into the wood it helps...

Cigarette burns: For small burnt or frayed areas, you can use a razor blade knife and cut out a little one or two inch square of carpet.

If your hollow exterior walls are allowing cold air to seep into your home, why not take a long weekend and insulate them? No, you don't have to rip open the walls. Your local home-improvement...

If your monthly heating bill is out of control and you can feel cold air leaking into your home from an uninsulated exterior wall, you don't have to rip apart the room to install insulation. A...

The easiest and most effective way to insulate a wall in your home is to staple up paper-backed fiberglass insulation between the studs while the wall is open for new construction or remodeling....

If you ever have had a drawer that has a knob that will not tighten or falls off completly there is an easy fix. You do not need any special skills.It will be as good as new. This is the most...

Got a hole in your drywall that requires more than just a little joint compound? I'll explain the right way to fix it with a patch that is lasting, strong and done the right way.

Vertical blinds are made from a rigid plastic material, metal or fabric. The problem with these blinds is eventually they will start to break down from wear and tear of turning them open and...

Moving wall art from one wall to another, or removing it completely, is something we all do from time to time. Left behind is that annoying nail hole that needs to be patched and painted. There is...

So your interior door got locked and you can't get it open? Different door knobs have different types of locks. Check out the steps below to see the various ways that a locked door can be easily...

Hanging large objects on the wall such as pictures, posters, mirrors, etc., may seem challenging. Follow these simple steps and you should be able to do it right.

Holes that are too big to smooth some spackle over, and too small to cut a replacement piece of wallboard to insert can be frustrating. This is a rather clever way to hold that spackle in place.

Blown-In insulation is an excellent material to insulate walls in existing structures. Blown-In insulation can also be used in attics. Proper insulation can reduce energy costs and improve the...

Basement ventilation systems are expensive. Why pay $ 1,500 when you can install your own in a few hours for less than $200.00 ? This won't have the fancy box and dials, but It'll vent your...

Fiberglass showers are inexpensive and fairly easy to keep clean. More and more homeowners have installed fiberglass showers and tubs in their homes in the past decade, as cast iron options have...

After purchasing a drywall kit from a home improvement store, use a drywall saw to remove the hole, and then, attach a new piece of drywall with screws. Tape, mud and sand drywall to patch the...

Explains a way to fix a hole in your wall.

If you have cable, then you have witnessed the cable worker making holes in your wall or the floor so that the coaxial cable appears. Perhaps you've seen this before and wondered how to do this...

Old houses and offices often use a lot of interior plasterwork. The plasterwork might look great, but if you accidentally fall into it with your elbow, you could end up with a hole in your wall....

Drilling holes into plexiglass needs to be done correctly or chipping and cracking can occur in the plexiglass. You can drill easily into plexiglass using a normal drill and metal-cutting drill...

Do your vertical blinds keep falling off? Here's a cheap easy and, honestly,a very, very lazy way to fix the blind

Many homes today have interior walls made of wall board, sheetrock or gypsum board. All three wall types are just pressed chalk between two sides of thick paper and are easily damaged. To repair a...

Make old furniture look new again! Learn tips for removing plug from furniture hole in this free woodworking video from a furniture restoration expert.

Furniture restoration made easy! Learn how to chip out plug to repair hole in furniture in this free woodworking video from a furniture restoration expert.

Most closet doors in mid century to modern homes are hollow. They are made of a lighter weight manufacturer wood or vinyl product. The reason the doors are hollow is to make them easy to...

If you own a home,store,or an apartment chances are you had someone daamage a wall

The problem with patching holes in a ceiling is that the drywall mud or spackle sags or falls straight out. There is a clever little trick to avoid this and make a perfectly smooth repair on any...

The screw hole is right where you want it to hold the door hinge in place, but it's worked its way free from the hole in the wood and is just hanging there. You try to screw it in again, but now...

Somebody spilled a glass of wine, dropped a cigarette or your new puppy had an "accident". Whatever caused it you now have big mark in your carpet and it's ugly. Don't despair, here's a good...

If a piece of veneer has come off of a favorite cabinet or tabletop then you need to do some wood veneer repair to the problem area. It is not a difficult task and can save a favorite piece and...

After you remove a screw from your wall you will be left with a hole that needs to be filled. Filling a hole in dry wall might be easier than you think and can be accomplished with materials that...

If your cabinet door is sagging, the solution may be as simple as tightening some screws. As long as you can wield a screwdriver, you're well on your way to fixing the sag yourself. Read the...