Do It Yourself Car Maintenance

Regular auto maintenance can save you time and money. More importantly, regular maintenance will insure a safer ride.

Troubleshooting your brakes on a GMC Sierra is a simple process. The brake system is a vacuum-controlled system that sends fluid through the brake lines and to the calipers. The fluid is what...

Brake lights occasionally burn out just like any other incandescent bulb. It's inconvenient for sure; fortunately, changing the bulb is easy. Car manufacturers understand that certain maintenance...

Car ramps are an excellent method of raising the end of an automobile for easy access to the undercarriage of the vehicle, removing the need to purchase more expensive hydraulic-powered floor...

One-man brake bleeding is most often accomplished using a hand-held vacuum pump to draw air out of the brake system. While the air is drawn out, new brake fluid is drawn into the system using the...

Rust is a terrible problem, and one type of material is particularly susceptible to rust, cast steel. On most cars, the brake calipers are made of cast steel, and as such, can get surface rust and...

Replacing the brake pads on your Mercury Topaz will save you time and money. The brake pads are the front lines in your stopping power, and maintenance will ensure your car always stops correctly...

When you are driving your car and you hear a high pitch squealing sound when braking, that is the squeal sensor. The squeal sensor was designed to let the driver know that the brake pads are...

As a general rule, maintenance programs are recommended in intervals of mileage or time, depending upon whichever milestone occurs first. Toyota provides the following minimum maintenance...

Some Chevrolet and GMC trucks equipped with the Duramax diesel engine come standard with an alert display in the dashboard. This alert system will let you know when to change your engine oil, when...

Jacking up a car is an easy procedure if the proper precautions and steps are followed. There are many procedures that require raising the rear end, including brake repair, axle removal and brake...

The Subaru Outback was originally a special trim level package of the Subaru Legacy, offered from 1995 to 1999. For the 2000 model year, Subaru took the Outback name and used it on an entirely new...

An automotive relay takes a small signal from some sort of actuator switch such as a brake pedal sensor, ignition key or reverse safety switch and uses it to activate the required circuit.

The parking brake helps to keep stress off of the vehicle's transmission while the vehicle is parked. It also acts as a backup to the hydraulic brake system in the event of a catastrophic failure....

You've notice a squealing sound coming from the front of your car when you apply the brakes. Chances are, you need new brake pads. You could take the car in, have it checked out and have the...

Instructions on how to change brake pads on Lexus LS430 2003.

This article will guide you step by step in changing the brake pads and rotors on a 6th generation Honda Civic.

The Ford Windstar was a minivan that was sold by Ford Motor Company from 1994 to 2003. During this time, the Windstar developed a long list of reliability issues including known head gasket...

The brake system should be included in your regular vehicle maintenance schedule. This includes inspection of brake pedal operation, brake fluid level, hoses, lines and wheel brake assemblies...

The disc brake assembly is one of the most important safety systems on your vehicle. Disc rotors, calipers and pads should be replaced when worn out or broken. Worn caliper pistons may leak. Disc...

The Ford Focus is an affordable, award-winning vehicle. These cars are incredibly popular, due to their small size, good gas mileage and low price. Ford has been making the Focus in North America...

Your car is an important part of your life. It can also be costly to buy a new one or to upkeep an old one. By utilizing four easy steps, you can save your car a lot of wear and tear and make your...

If the fluid in the clutch master cylinder reservoir is dark, or the clutch lever feels soft and spongy when pulled in, it may be time to bleed (or replace) your clutch system. Flushing and...

Brake pads will wear out eventually, and if they're not replaced when they become well-worn, they can damage rotors and diminish braking capability, causing potentially dangerous conditions....

The Honda Accord is a reliable, fuel-efficient family sedan. To maintain the best possible braking power, the brake shoes on the rear wheels occasionally will have to be replaced. It is a...

Replacing the booster Brake is not so hard as it can be tedious. There is really only one difficult step in the task and that is removing the clip holding the booster brake rod to the brake pedal....

This eHow with photos will teach you how to remove and replace the Brake Master Cylinder of your Neon auto. With the proper tools this is a rather moderately easy task.

If you want to keep a car from breaking down, you have to be willing to give it the care it deserves. Just like any item you own, a car will last longer if you take proper car of it. This will,...

Many car manufacturers recommend replacing the brake pads on your car whenever the lining has worn out down to 1/8-inches or less. You can actually remove the tire and wheel assembly and measure...

As a practical matter, the brake lights are an important safety feature that should be checked at least twice a year. Many states in America require annual inspections, and your Audi will not pass...

The brake pads on your vehicle should be inspected every 12,000 miles or every year. By removing the tire, you can measure the brake pad lining thickness with a straight rule. If the lining is...

Whenever a repair is done on any part of your Scion xB's manual transmission system, air will make its way into the hydraulic fluid. This air will cause your clutch to perform poorly, giving the...

This article will show you step by step how to change the brake pads on a 2006 Honda Pilot. When purchasing a brake pad set consider the quality brands such as Hawk brake pads, akebono brake...

Changing your own brake pads, even in a large vehicle like the 2002 Chevrolet Trailblazer, is a relatively light-duty car maintenance task. Many of the required tools can be found in the spare...

The brake rotor on your vehicle uses the friction from the brake pads to help you slow or stop the car. However, a rusted rotor will not be able to do its job properly and will probably seize to...

The brake rotors on your motorcycle help to slow it down. While the rotor itself spins with the wheel, a caliper assembly fits over part of the surface of the rotor. When the brakes are engaged,...

The Volkswagen Jetta inline-four cylinder turbocharged direct injection engine (or TDI) is renown for its reliability and durability, with some engines running over 300,000 miles before needing...

Brake pads are a consumable part of a vehicle's braking system and are specifically designed to wear out over time. Brake pads are the point of friction in a braking system. Friction causes...

Even if you don't have a garage packed with professional mechanic's tools, you can still change your own Nissan Maxima brake pads. This is a relatively straightforward operation that takes about...

Replacing your Hyundai Elantra's brakes is a relatively quick and simple job, even for amateur home mechanics. If you have all of the proper tools at your disposal, you should be able to replace...

Changing a car's rear brakes is not an especially difficult auto maintenance task, and the process tends not to vary too much from one make and model to the next. Assuming that you have all of the...

If your motorcycle's hydraulic brakes or clutch release systems have gone or have always been squishy and without strong power, this could be because they need to be bled. Over time, brake fluid...

Brake systems work on hydraulic pressure carried to each tire using a group of components that include brake lines. Brake lines can be made out a variety of materials, from stainless steel to...

The Pontiac G6 brake lights are an important part of a vehicle's brake and safety system. The bulbs used in the G6's brake lights are low wattage and should last quite a long time. However,...

The brake system on a Chrysler Conquest TSI works by hydraulic pressure. However, the system will only work when there is only hydraulic brake fluid in the brake lines and no air. If there is air...

Well maintained brake rotors are an integral element in your automobile's overall performance and safety. Worn or warped rotors can cause vibrations, violent shaking while braking, and diminished...

The method for installing new brake pads on a Toyota Tundra varies slightly based on whether you have a two-wheel-drive (2WD) or four-wheel-drive (4WD) model, but the steps are basically quite...

Brakes are the most important safety feature on a car: Faulty brakes can cause accidents, so it is important to keep your vehicle's brakes in good working order. Save time and money by replacing...

When brake systems are adjusted or replaced, they must be purged of air before use. So, if you aren't sure if your vehicle's master cylinder brake system has been purged, there are a few steps you...

Bleeding your brakes is necessary for a functional brake system. The Brembo brake system uses standard hydraulic fluid to force a piston against its brake pads and in turn against its rotor. If...