Fluorescent and incandescent lights are two of the most popular choices for home lighting. For many years, incandescent lighting has been preferred, but fluorescent lights are beginning to gain popularity due to their energy savings and long lives. Because of the energy savings of fluorescent lights, they do not need to use as many watts as incandescent versions.
Equivalent wattage is judged based on lumens, or the measurement of how much light a bulb produces. Essentially, if both fluorescent and incandescent bulbs produce the same amount of light, their respective wattages will be equivalent, showing how much energy it takes to make the same amount of light. For lumens in 500 to 600 range, it takes about 55 watts for an incandescent bulb to operate, while it takes only 10 watts for a fluorescent light. A 75-watt energy use on an incandescent light would only need to be 11 to 15 watts on a fluorescent light.
Light Bulb Comparison
While equivalent wattage numbers are useful for showing the difference between the two types of bulbs, it is not as useful when choosing the bulbs themselves. Bulbs only come in certain wattages, which make equivalent versions slight different. A 9-watt fluorescent bulb, in this case, is equal to a 40-watt incandescent bulb. Around 20 to 20 watts in a fluorescent bulb is the same as 100 watts in an incandescent bulb. Differences will also occur between types and sizes of light bulbs.
Fluorescent lights use a special inert gas and a powder coating on the inside of their bulbs to produce lights. The electrical current cycles through the gas and excites its atoms. After each cycle the atoms release their energy in small bursts, which then hit the atoms of the powder coating. The coating atoms react in the same way, but the energy they release is actually light. This process uses electricity very efficiently.
Incandescent lights use a specialized resistor that slows down the electricity that flows through it. Some of the electrical energy is given off as light, but a lot is given off as heat, which is why these bulbs are not as efficient. The bulb must be air tight so the resistor filament does not burn out.
Incandescent light tends to be a warm white color, mostly because its light wavelengths pass beyond the visible spectrum and include many infrared wavelengths. This range, including red visible and invisible light, gives it a more natural color. Fluorescent lights tend to be white or bluish, but their color depends on the temperature of the light produced, with light around 6500 Kelvin produced wavelengths across the spectrum in a way similar to daylight.
- Photo Credit Light bulb image by Mart61 from Fotolia.com
Fluorescent vs. Incandescent Light Output
Both incandescent and fluorescent bulbs are widely used to provide consumers with artificial light to illuminate their lives. In terms of light...
Difference Between a T5 & T8 Fluorescent Light
Linear fluorescent lights are often used to light classrooms, office buildings and doctors' offices. The fixtures all appear the same, but there...
T5 Vs. T8 Bulbs
The T5 and T8 designations for fluorescent bulbs refer to the tube diameters. A T5 bulb is 5/8-inch in diameter, and a...
How to Convert Incandescent Wattage to Compact Fluorescent
Compact fluorescent lamps (CFLs) save energy over conventional incandescent bulbs by producing the same amount of light at a lower wattage. While...
How to Compare the Brightness of LED Lights and Wattage
Brightness and wattage are actually two different things. Lumens are the units used to measure light intensity or brightness, while wattage is...
How Much Energy Does a Fluorescent Fixture Use?
Fluorescent light fixtures in general produce more light for equivalent amounts of energy when matched against incandescent lights. The same goes for...
How to Convert Incandescent Watts to LED Watts
Light-emitting diode, or LED, bulbs are much more energy efficient than "old school" incandescent bulbs. This means that it takes less power,...