How to Make a cut greater than 45 degrees on a Miter Saw

eHow may earn compensation through affiliate links in this story. Learn more about our affiliate and product review process here.

Things You'll Need

  • Power Miter saw

  • strips of wood, 3/4" thick (preferably plywood) x 1-1/2" and 4" wide

  • nails or screws

  • Protractor

Making a cut greater than 45° on a Miter Saw

Power Miter saws are great for cutting wood, plastic and softer metals up to a 45° angle, but what if a greater (or sharper) angle is required? Use this simple technique to make cuts greater than a 45 degree angle.

Advertisement

Step 1

Secure a piece of wood approximately 4" wide to your power miter saw. My saw is mounted to a bench with blocks on each end the same height as the base of the saw to which this strip is attached.

Advertisement

Video of the Day

Step 2

Cut a 1-1/2" strip about 3 feet long in half with the saw at a 45 degree angle.

Advertisement

Step 3

Remove the 1-1/2" pieces and turn the saw to the opposite 45 degree mark and make another cut into the 4" base.

Advertisement

At this point the 1-1/2" strips could be attached to the 4" base lined up with the 2 cut lines. I found it best on my saw to use one of the 1-1/2" strips (on edge) as a spacer to mount the two 1-1/2" pieces for additional space. Adjust this for your saw as necessary.

Step 4

Mount the 2 pieces to the 4" base to form a new "fence" for your saw.

Advertisement

Step 5

When the workpiece is cut with the saw at the "0" degree mark, it will automatically be at a 45 degree angle. 2 cuts may be necessary as the opposite "fence" may not allow the workpiece to be placed far enough into the saw.

Advertisement

Advertisement

Step 6

Cutting the opposite side makes a perfect 90 degree miter joint.

Advertisement

Step 7

For applications where the angle is less than 90 degrees, use a protractor to measure the angle of the area where the workpieces will be installed. In the picture, the angle is 45 degrees.

Advertisement

Step 8

Divide this angle in half, which will be 22.5 degrees.

Subtracting 22.5 degrees from 45 degrees equals 22.5 degrees.

Set your saw on 22.5 degrees to cut the angle.

Step 9

Cut both pieces to form the joint. Again, 2 cuts may be needed to cut the angle properly.

***Use clamps as needed to help hold the workpiece in place as the space between the new "fence" and the blade is tight and the cut will be longer. The blade may tend to "pull" the workpiece (and your hand) toward the rear of the saw if it isn't held securely.

Step 10

Check the fit of the joint. The longer (sharper) the angle, the more difficult it will be to achieve a tight fit. Use a scrap piece to test the angle prior to cutting the actual workpiece.

Warning

Remember shop safety!! Use caution around any power saw!

Advertisement

Video of the Day

Report an Issue

screenshot of the current page

Screenshot loading...